The Heaters for Public Service Equipment
- Eliminate Winter Idling
- Lower Working place exhaust emissions
- Increase cold weather utilization
- Improve operator productivity
- Reduce cranking system wear
- Extend doc / dpf life
- Eliminate the need for plug-ins
Different Configurations for Different Applications
Espar air and coolant heaters can be costumized to suit your specific needs. Espar coolant heaters are boxed for protection and offer amp management solutions utilizing our auto-shut-off switch. With Espar heaters you can be assured of higher equipment reliability without idling. Wheater it’s for pickup trucks, on highway trucks, off-road equipment or smaller nonmobile equipment, Espar’s E-Work heaters save fuel, increase productivity and reduce emissions. These units are bio-diesel compatible and come in 12 and 24 volt models.
AIRTRONIC D2 and D5 Series
AIRTRONIC units range from 2 kW / 7,500 BTU’s to 5 kW / 18,800 BTU’s and are available with our Digi-controller, which has an internal ambient air temperature sensor for precise compartment heating, All without idling the engine.
HYDRONIC D5 & MII Series
HYDRONIC units range from 5 kW or 17,000 BTU’s up to 12 kW or 42,000 BTU’s and are available boxed for protection. The MII series have automatic altitude compensation and multiple operating speeds for reduced amp draw. Both are available in 12 or 24 volt and have a variety of timers and controls available and are compact enough to be mounted in a variety of locations.
- Indicates on-board diagnostics capability
- 7 Day Timers*
- Programmable Timer
- Push/Pull Switch
- Auto Shut-Off Switch
Easy to Operate
E-Work heaters operate as miniature furnaces independent of the engine, utilizing the units own diesel fuel and batteries to produce heat.
E-Work HYDRONIC coolant heater can pre-heat the engine, indirectly heat the cab, crew shelter, fuel tank, hydraulic tank and other service fluids.
E-Work HYDRONIC air heaters can provide ample heat to the cab, mobile work stations, crew shelters, all without idling the engine.
Using timer controls, the E-Works heaters can be switched on to begin engine pre-heating at preset intervals, saving fuel and allowing operators to go directly to work upon arrival.